Quick Start User Guide
Egg-Jet20 R5/R6/SOR
1
It’s important to clean your ink cartridges daily before use to maintain good print quality and proper
functioning of the cartridges. Dust and dried up ink will start to build up on the nozzle and clog up the tiny
holes where the ink has to come out of.
The cartridge will get blocked if not properly cleaned!
1. Use a CLEAN tissue or paper towel
to clean the nozzle of the ink cartridge.
2. Clean the nozzle by pulling it in a line
over the tissue using your index finger
on the other side of the tissue.
3. You may need to repeat this a couple of
times to get the cartridge to work
properly again.
4. Make sure to clean the gold contact
points to ensure good connection with
the printhead.
Clean the ink cartridges daily before use
Insert the ink cartridges into the Egg-Jet20 printer
Cartridge cleaning procedure
Lift up the locker [1] completely and place the ink
cartridge carefully into the bottom positioning points [2]
of the printhead cartridge plate from above.
Press the ink cartridge carefully into the printhead
(against the back of the cartridge plate) with
one hand and apply a light counter pressure on the back
of te cartridge plate with the other hand.
Bring down the locker to keep the ink cartridge in place.
The locker should fall over the little latch on the ink
cartridge, so it “clicks” into the printhead.
Check before use if each cartridge is placed correctly!
If the cartridge is not placed correctly all the way against
the back of the printhead, some contact points with not
have a good connection and cause a bad imprint.
2
2
1
