Symbologies setting
- Enable - Disable
How do you program your scanner?
1.Scan Start Configuration
2.Scan all necessary able for parameters that
Meet your application
3.Scan end configuration to save the changes.
Resetting The Standard Product Defaults
If you aren’t sure what programming options are in your scanner
,
or you’ve changed some options and want the factory settings
restored, scan the bar code below
.
End Confi
guration
I
nterface selection
Reading mode
Language ………etc.
Start Confi
guration
Standard Product Default Setting
WIRELESS BARCODE SCANNER
Quick Start Guide
KC-5200ZB
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures: -Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user's
authority to operate the equipment.
Labeling requirements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
RF exposure warning
The equipment complies with FCC RF exposure limits set forth
for an uncontrolled environment.The equipment must not be
co-located or operating in conjunction with any other antenna or transmitter.