NuEyes Quick Start
READ THESE INSTRUCTIONS IN ORDER
1. Master one section at a time.
2.
All “left/right” directions are how you would reach
up to the head set
when it’s on your head.
3. Put the goggles on before turning it on. It will be
totally dark. It can sense position. It goes to sleep
when you take it off for even a few seconds to save
the battery. After you get to know how that works,
it
doesn’t matter if it’s on your head or off as you
power up.
4. You can adjust the side straps with the tabs on
either side of your head. If you need the top strap
longer, pull one side of the loose end of the inside
strap to release a rubber button.
SECTION ONE
ORIENTATION TO Buttons
1. Power Button: under right corner near the
front edge.
Note: The other tactile marking under the
right side is just to mark the charging port.
Three buttons positioned vertically on right side:
2.
Zoom In: “Button 1” top right with one
tactile indicator.
3.
Zoom Out: “Button 2” second one down with
two tactile indicators.
4.
Enter VR Mode: “Button 3” AKA “Home
Button” lowest on the right side – no tactile
indicator. It feels indented/concaved.
Do NOT press Home Button until you
master the NuEyes Mode AND
read all about VR Mode in Section Two
“Home Button” on head set feels indented
just like the Home Button on the remote.
5. Two buttons under left corner.
- Contrast/Color Change: use either button
to scroll through colors: Blue, Orange
natural color, enhanced positive and
enhanced negative.
OR
- Volume Up and Down
: only when you’re
listening to something.
6.
Remote
: There is
no
“power” button on the
remote. You can only activate it when you
“power on” the headset. You only
need
it in
VR Mode.
Two buttons for basic use:
- Trigger: use pointer finger to pull
works as a mouse click
- Home Button: feels indented/concaved
use thumb to press
POWER UP - TO NuEyes MODE
1.
After
reading Section One, read through this
section again before putting it on.
2.
Get the controller handy. It’s optional for
NuEyes Mode. But you can only sync it
(activate it) while powering up.
3. On head set, push-hold power button for 2
full seconds. (under right front edge)
4. After short pause:
see “NuEyes” logo, hear
a jingle, see
“Loading”.
5. You may see a moving blue donut and a
pencil drawing of the remote. You have 10
seconds to quick press the Home Button on
remote to sync the remote.
6. You may see (first time it powers up):
“Do Not Drive or Walk With This Device”.
7. In NuEyes Mode, you may:
Zoom-In
Zoom-Out
Change Color
SECTION TWO
Virtual Reality Mode (VR Mode)
Switch Between NuEyes Mode and VR Mode
1. From NuEyes Mode, quick press Home
Button (either on the remote OR on the
head set).
2. Each of the 6 tiles on screen represents a
application.
3. To go back to NuEyes Mode: Point remote
beam (blue +) at the top left tile (Blue Circle
with white “e2” logo). Pull trigger to select.
4. Go to step one
-------------
