6 Ver. 0.2
-
The clamping position and relatively acceptable loading is shown in Fig. 2.4 ~ Fig. 2.5.
-
The clamps must be fastened to supporting structure using M8 stainless steel hardware (all fitting
components must be corrosion-proof material).
-
The applied torque is about 8 N-m.
-
The modules are supported parallel to surface of the building wall or roof. Sufficient clearance
(recommended is 140 mm) between the module frame and mounting surface of the wall or roof is
required to prevent wiring damage and allow cool air to circulate behind the module.
Fig. 2.2
Fig. 2.1
Fig. 2.3
Clamp A
Clamp B