NSK iClave Plus, Руководство по эксплуатации, Страница: 19 / 36

17
To unlock the door before opening it, press the key
Start/Stop
.
The cycle is over and the load can be taken out .
ATTENTION: instrument and chambers are hot
If a label printer is used, at the end of the cycle the display will ask to select the number of labels need-
ed, select the value with UP and DOWN, than opening the door the printer will release the labels.
Opening the door, the displays will show again the current time, chamber temperature and pressure,
and the sterilizer is ready for a new cycle.
If an external serial printer is connected, a report will be issued during the cycle phases with the more
significant data; the report can be filed as proof of the sterilization process performed.
The operator can arrange other load on the trays and start a new sterilization cycle. with the advantage
of shorter heating-up time as the chamber is already warm, or press key
Power
to put the unit in
stand-by status (OFF on the display) .

If the door is not opened or a key pressed within 30 minutes, the unit switches to stand-by
(OFF) automatically
.
WARNING :
Should any failure or error occur during the cycle, Led Alarm turns on, the display Time will show the
type of alarm (see chapter ALARM) and the door remains locked. To unlock the door, press key
Start/Stop
.
ATTENTION: instrument and chambers are very hot.
Contamination risk.
4.4 STOPPING THE CYCLE
To stop the sterilization cycle, press key
Start/Stop
.
T
he display Time shows the message “
MANUAL STOP
”.
Before opening the door, make sure that the display Pressure is showing the value 0. A safety device locks
the handle when the chamber under pressure. To unlock the door press key
Start/Stop
.
Remove the load and check for the presence of water into the chamber. In case of wrapped instruments, we
suggest to replace with new bags.
Before loading the chamber again, dry it carefully and wait 10 minutes to allow the water to evaporate and be
drained completely.