1
USER INSTRUCTIONS
NUVO SLATTED BATH / SHOWER BOARDS
L71134
Bath Board 26½” (673mm)
L71146
Bath Board 27½” (698mm)
L71158
Bath Board 28½” (724mm)
L71169
Bath Board 30” (762mm)
L71171
Shower Board 26½” (673mm)
L71183
Shower Board 27½” (698mm
L71195
Shower Board 28½” (724mm)
L71274
Grab Handle (optional)
General Safety Warning
Please make sure that you read and follow
these instructions carefully. Keep these
instructions in a safe place for future reference.
Maximum User Weight
30st
190kg
1. INTENDED
USE
The NuvoTM Slatted Bath/Shower Board is designed
to provide a safe seating or transfer platform for use
when bathing or showering. It can be used on its
own or in conjunction with the NuvoTM Bath Seat to
allow the user to sit lower in the bath.
2. SAFETY
Warning:
The maximum user weight must not be
more than 190Kg (30st).
Check the bath seat
fi
ts correctly inside the bath.
There should be a minimum of 1.5” (37mm) of level
bath rim on each side to support the board.
Ensure the wing nuts are tight and the clamps are
secure prior to use.
Do not attempt to stand on the seat.
3. UNPACKING
Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are
missing or damaged and do not try and assemble.
3.1 Contents:
A. Bracket Pads x 8
B. Bracket Locators x 4
C. Wing Nuts x 4
4. ASSEMBLY
A
C
B
Push the bracket pads (A) into the bracket locators
(B).
Attach the clamp bracket to the underside of the
board by screwing the wing nut (C) through the
central slot into the corresponding screw thread.
5. INSTALLATION
1. Choose the desired position of the bath board.
NRS advise the optimum position to be at the
end opposite the taps.
2. Clean and dry the bath walls thoroughly in the
area where the board is to be
fi
tted.
3. Place the board across the top of the bath with
the brackets facing upwards and the edge of the
board in line with the edge of the bath.
4. Slide one of the brackets such that the bracket
pad is in line with the inside edge of the bath and
secure by tightening the wing nut.
5. Take care not to over-tighten the wing nut.
6. Turn the bath board over and locate the ‘
fi
xed’
bracket in position at the inside far edge of the
bath.
