NRI G-13.mft MDB/S1, Руководство по эксплуатации

Страница: 28 / 65

S
TARTING UP
G-13.mft MDB/S1
28
National Rejectors, Inc. GmbH, Buxtehude
Installation of the NRI sorting device ...
If you want to operate the G-13.mft with the NRI sorting device, you must use
a special bracket to install the NRI sorting device on the top entry model or
on the front entry model:
... on the top entry model
1
If necessary, fasten chute extension 1 with screw 2 to sorting
device 3 (see Fig. 5a).
2
Fasten mounting frame 4 by means of screws 5 and 6 to the rear of
the sorting device.
3
Hang the coin validator by its mounting studs 7 in the mounting
frame.
4
Use the 3-pole sorting plug 8 on the PCB 9 and on the rear of the
coin validator to connect the sorting device to the G-13.mft with the
help of the appropriate sorting cable.
5
Use the 10-pole connecting plug 10 on the PCB 9 and on the rear of
the coin validator to connect the sorting device to the G-13.mft for
power supply of the sorting solenoids with the help of the appropriate
connecting cable.
6
Use the 10-pole connecting plug 10 on the PCB 9 and the same
connecting cable to connect the coin validator to the vending
machine (see also section "Starting up in the vending machine" in
this chapter).