NRG INSTRUCTIONS
Windcube PV Trailer
Windcube_PVTrailer_ModerateClimate_Instructions
Rev. 2
[email protected] | Page 6
27 March 2018
e.
Repeat d. and f. for remaining panels.
7.
Connect each PV panel’s male and female connectors to the trailer’s male and female connectors.
NOTE: Male connectors attach to female connectors.
Section 3: Windcube Placement
1.
Install the Windcube platform.
a.
Remove nut and washer from pedestal support.
b.
Loosen storage bolts on either side of stowed platform.
c.
Lower platform into position and replace washer and nut on the pedestal support; hand tighten.
2.
Install Windcube on platform.
a.
Install the Windcube on the platform so it is facing North.
b.
Attach the Windcube antenna to one of the two Antenna Mounts and push the end of the antenna
cable through the strain relief on the front of the trailer into the inside of the trailer. It may be
necessary to pull out the rubber gasket in the strain relief, slip it over the cable and then reinsert it
Antenna Mounts
Pedestal Support
Storage Bolts