NRG Product Manual
Hybrid XT Anemometer
HybridXT_Anemometer_Manual
Rev. 15
[email protected] | Page 17
02 January 2020
Mount Sensor
To attach the sensor to the mounting mast,
slide the clamp bolt and washer away from the
mounting mast until the nut is against the
mounting mast and is hanging vertically.
Rotate the HXT sensor body so that the “THIS
SIDE TOWARD ROTOR” label is facing the
turbine rotor. This aligns the internal key with
the alignment slot in the connector. Now, slide
the sensor down over the boom carefully
making sure that the key drops into the slot.
Continue to slide the senor down until it is
firmly seated on the nut. There will be some
drag as the o-ring seal and the connector pins
engage. Tighten the bolt using a 10 mm wrench
to 7 N-m (5 ft-lbs).
Replacement washers, nuts and bolts can be ordered from NRG Systems (part #4422).
Nut against mast
and hanging
vertically.
Bolt & washer away
from mast
Slide sensor down over mast.
“THIS SIDE TOWARD
ROTOR”
