REMOTE CONTROL RC- 101QM
2
[01] Power On / Off (depending on the model)
[02] Mute
[03] OK
[04] Direction Keys
[05] Mouse Activation Key
[06] Right Click
[07] Left Click
[08] Home
[09] Back
1.Installation
Connect the wireless receiver into an USB port on your android device
or computer. Once communication is established between the remote control
and receiver, you can see and control the pointer.
*Tip:
If the LED on the remote lights up but the pointer does not move....
Press and hold the [ENTER] and the [C] keys, the LED on
the keyboard lights for 5 seconds while the motion mouse enters the auto-
matic pairing state; When the mini-receiver’s LED turns on, it means that
*Tip:
Press the navigation key once to activate or block the remote control. If the
LED of the remote control doesn’t light up , means that the remote is running
out of battery, please connect the micro USB cable to recharge the battery;
the left red LED of the remote will flash while charging.
Enter key
C key
2. Function Mouse/Pointer:
Press the navigation key once to activate or block the remote control.
Hold the remote in any position and point in any direction; you can move the
pointer on the screen easily with slight turns of the wrist.
3. Key Functions
Keyboard area
It is the main component of the keyboard, with the standard keyboard layout.
This key area includes a numeric keypad, alphabetic keys, and common punc-
tuation keys; In addition there are a few essential control keys.
ALT Key: Toggles between the two functions of the buttons
，
works only while
pressed
HOME Key
:
Same function as the WINDOWS key
Other key functions are the same as in a standard keyboard..
ENTER+S
：
Sensitivity adjustment
ENTER+A
：
Initialization.
Note
:
When the cursor drifts, keep the unit held stationary flat on your desktop, while
pressing and holding down the ENTER+A for 5s, the LED will light; after 5s the
LED will be off, which means is being initialized. Please do not release the keys
until the LED will turn on again signalling the end of the initialization.
4. Mouse function key area:
Mouse Activation Key: Hold down the button to activate the motion
mouse cursor; Release the button to position the cursor
.
Left Mouse button.Consistent with the standard mouse left button func-
tions
．
Right mouse button: Consistent with the standard mouse right button
functions.
LED status display:
If you press any key on keyboard side,and the indicator LED flashes slowly at
4Hz,indicates that no connection has been achieved - a steady light indicates a
successful connection.
5.Qwerty Keyboard
1
2
1- Previous Page
2- Next Page
When this side is up, you must press any key to activate the input from this key-
board. These keys are not operational when they are down.
Caps Lock. Pressing [Caps], capital letters are entered, press [Caps] to return to
lowercase.
Use a USB connector of the controlled device or an electrical USB adapter ( 5V
) to charge the internal lithium battery of the remote control.
A full charge can take an hour and a half or so.
Low battery. In operating mode, if the output voltage of the battery is below
3.7V DC, the LED flashes to indicate it needs charging.
When charging is complete, disconnect the USB cable..
6. Charging
User Manual
Micro USB
Connecter
USB Port(Android Device, TV, PC.)
Micro USB
Connecter
1
2
3
3
7
9
1
4
5
6
8
