NVB
-
6050JB
-
user
’
s manual ver. 1.0
All rights reserved © AAT Holding S. A.
5. Installation manual
Pick a suitable location and provide all necessary wiring in desired adaptor mounting place, mark
mounting holes and drill them in selected locations.
1. Open lower cover and upper cover of the adaptor by loosening the fixing screw and turning the upper
cover counterclockwise.
2. Fix the lower cover of the adaptor to the wall or ceiling in selected location.
3. Remove the base of the camera.
4. Fix the base of the camera to the upper cover of the adaptor.
5. Install the camera to the camera base, then route the cables through the cable hole and connect the
cables.
6. Install the upper cover of the adaptor with camera to the lower cover with a clockwise rotation and
then secure the upper cover by tightening the fixing screw.
CAUTION: Pay special attention to ensuring that the surface to which the camera adaptor
is attached is even and has a suitable load capacity.
WARNING! The adaptor is intended for indoor use and is not moisture resistant. The
manufacturer is not responsible for damages to the camera related to water getting through the
handles or adaptors to the camera or its connectors.
AAT Holding S.A., 431 Pulawska St., 02-801 Warsaw, Poland
tel.: +4822 546 07 00, faks: +4822 546 07 59
www.novuscctv.com
09.03.2020 JZ MK
NVB-6050JB
1
2
3
4
5
6
Fixing screw
Lower cover
Upper cover
Camera base
Camera
