NOVUS AUTOMATION
44/57
7.3.2.7
TIMER
This tab allows you to configure the parameters related to the timers:
QuickTune
QuickTune Mobile
Timer tab
•
Criterion for starting the timer counting:
Allows you to define a criterion to start the timer counting: “Disabled Timer”, “Triggers when PV=SP”,
“Triggers when press F key”, “Triggers when Control Enabled” or “Triggers with DI” (see
section).
•
Timer counting mode:
Allows you to define the timer counting mode: “Forward (UP)” or “Backward (DN)”.
•
Timer time base:
Allows you to define the timer time base: “Minutes:Seconds” or “Hours:Minutes”.
•
Time of timer 1:
Allows you to define the timer 1 time. Range: 99:59 (in minutes) or 0 to 9999 (in seconds), as configured in the
Timer Time
Base
parameter.
•
Displays timer 1 edit screen in the Operation Cycle:
If enabled, the timer 1 editing screen will be displayed in the Operation Cycle of the
device.
•
Criterion for ending the timer counting:
Allows you to define a criterion for ending the timer counting: “Output off at the end of T1” or “Output
on at the end of T1”.
•
Time of timer 2:
Allows you to define the timer 2 time. Range: 99:59 (in minutes) or 0 to 9999 (in seconds), as configured in the
Timer Time
Base
parameter.