RDC.OD.TP-2020.000 OM
Operation manual
Coating Thickness Gauge NOVOTEST TP-2020
Page 28
3.3.3 Warranty for repaired or replaced parts
All branded parts of NOVOTEST installed during the warranty repair apply to the NOVOTEST
warranty (up to the end of the warranty period).
The spare parts replaced during the warranty service, shall not be returned to the device owner.
3.3.4 Wearing parts
The parts wearing during the device operation are divided into two main categories. The first part
includes the parts that need to be replaced or adjusted with the frequency stipulated by the maintenance
schedule of the device, and the second part includes the wearing parts, which frequency of replacement
or adjustment depends on the conditions of the product operation.
3.3.4.1 The parts replaced during the maintenance
The parts listed above have a limited service life and need replacement or adjustment with the
frequency stipulated by the maintenance schedule of the device. For these parts, the basic warranty
applies before the first replacement or adjustment. The warranty period for each part shall not exceed
the limitations (by the time of operation of the device or working hours), specified in the conditions of
the basic warranty.
−
built-in batteries;
−
gaskets if they are removed due to adjustment;
−
oil and working fluids.
3.3.4.2 Wearing parts
The parts listed below have limited service life or need to be replaced (adjusted) due to the damage.
However, these parts are subject to the basic warranty of NOVOTEST for 12 months:
−
probes and their components;
−
connecting cables;
−
parts and mechanisms exposed to mechanical impact during operation.
Note: The parts wearing due to friction (such as movable parts of measuring probes, ultrasonic
piezoelectric probes, support arm etc.) are not covered by the basic NOVOTEST warranty if these parts
are damaged due to wear and tear during the device operation. However, if in the warranty period these
parts fail due to defect of material or workmanship, they shall be repaired or replaced under the basic
warranty.
3.3.5 Owner obligations
The «Operating manual» and «Datasheet» contains the information about right operation and
maintenance of your device.
Proper operation and maintenance of the device will help avoid costly repairs caused by incorrect
operation, negligence or improper maintenance. Besides, following our recommendations will extend
the service life of the device. Therefore, the device owner should:
−
If any defect or fault is found, submit the device to NOVOTEST or the authorized dealer of
NOVOTEST for a warranty repair as soon as possible. This can minimize the repair required
for the device.
−
Perform maintenance of your device in line with the recommendations of the operating
manual and passport.
Note: Failure to perform the timely maintenance of the device in accordance with the prescribed
schedule will void your rights to the warranty repair or replacement of defective parts.
−
Use only branded spare parts and couplants of NOVOTEST (with appropriate labels).