RDC.OD.TP-2020.000 OM
Operation manual
Coating Thickness Gauge NOVOTEST TP-2020
Page 18
Figure 2.21 – Viewing of the memory condition
Figure 2.22 – Viewing of the memory condition
2.3.8 «INFORMATION» section
In this menu item, user can view the serial number of the device and probe and the firmware version
of the thickness gauge (fig. 2.23).
Figure 2.23 – Viewing of the factory numbers of the device and probe, and the firmware version
2.3.9 Measurements
1.
Connect the probe and turn the device on by pressing «
».
2.
Zero the probe (see c. 2.3.3).
3.
Set the probe on the test object or coated part upright, and press it to down (fig. 2.24) without
wiggling.
Figure 2.24 – Setting the probe on the coated object
4.
When the device makes a measurement, the sound signal will be generated, and the display will
show the measurement result.
5.
Once the repeated signal will sound, the device will be ready for the new measurement. The
display will show the recent measurement of the coating thickness (fig. 2.25), changing only
upon the next measurement.