–1–
Pun M
™
NDX Mobile Finger Punch
Rack and Rotation Guide Upgrade Kit Instructions
General Information
Pun M NDX 114: Item Code 104635
Pun M NDX 200: Item Code 104636
Rack and Rotation Guide Upgrade Kit
Step 3. To remove rack, loosen and remove
four fasteners on belt support plate.
Discard fasteners.
Revision 1: has counterbored holes for rack
fasteners.
Revision 2: has countersunk holes for rack
fasteners.
Note: both styles of fasteners are included in
repair kit for replacement.
Step 6. Loosen, but don’t remove, five
frame shoulder fasteners on one side
of punch.
Step 7. Remove three bottom plate
mounting fasteners on each side of punch.
Step 8. Remove bottom plate assembly,
set aside.
Step 4. To install new rack, place belt support
plate on top of rack, aligning fastener holes.
NOTE: If available, place a drop of low strength
threadlocker on the beginning thread of each
fastener prior to placing in hole.
Secure belt support plate to rack using four
new fasteners provided.
Step 5. Lock crank handle in the up
position and lay punch on its back.
Step 2. Remove belt support plate by
removing four fasteners on corners of
plate. Save fasteners for reuse.
Tools Needed:
4mm Hex Key
3mm Hex Key (some models)
T20 Torx Wrench
Step 1. Remove punch pad by
removing two fasteners at front
corners. Save fasteners for reuse.
Rev. 1 Rev. 2
