Prior to use please read all instructions
Suitable for most ‘A’ framed wheeled
walkers; consult the manufacturer’s
manual to confirm suitability
Do not use with oxygen cylinders
larger than 125 mm in diameter
(maximum ‘C’ size)
Suitable for all BetterLiving Wheeled
Walker models excluding the Tri-
Wheel and Shopper
To attach the carrier
Remove the wire shopping basket (if applicable)
and slightly fold the wheeled walker.
Vinyl bags do not need to be removed.
Position the oxygen bottle carrier with the open end facing
your preferred side.
Hook the carrier onto the crossbars
underneath the seat; 2 hooks over rear
bar followed by 2 hooks over front bar.
Unfold the wheeled walker and check
oxygen bottle carrier is secure before
closing the seat.
Note,
hooks may not sit flush
against the crossbar; this
is acceptable as long as
carrier is secure and
firmly attached to the
wheeled walker.
If intending to use the seat function;
we recommend that
the wire basket is not
reinserted while the
oxygen bottle carrier is
attached (to ensure full closure of the seat).
To install the oxygen bottle
Unscrew the locking pin at the top of the carrier until the
rubber stopper is flush with the edge (do not remove
completely).
Designed to fit under the seat of
most ‘A’ frame wheeled walkers,
the oxygen bottle carrier suits an
oxygen cylinder up to 125 mm in
diameter (‘C’ size). Carrier is angled
slightly for optimal oxygen supply
and to prevent the oxygen bottle
from sliding out.
Slide the oxygen cylinder into the open end of the carrier, valve
end first (so valve is positioned against the closed end of the
carrier). Tighten the locking pin until the rubber stopper sits
firmly against the oxygen bottle to secure.
Check the bottle is secure and fully inserted before use.
cross section
of cross bar
Oxygen Bottle Carrier
S E T U P A N D O P E R A T I O N
