User Manual
XLP 604
Missing labels
Normally a missing label on the label web does not interfere with print operation. Label feed continues
running until the start of a label has moved up under the label sensor again.
It may be necessary in some cases, however, to report the missing labels. When function
System
>
Print Control
>
Miss. label tol.
is set, an error message can be generated after one, or after several
missing labels:
Status num: 5001
No gap found
At the same time the printer stops.
Ribbon reserve
The ribbon reserve is displayed during printing as remaining length in meter (A):
Fig. 44: Display of the remaining ribbon length (A, here: 35 m).
The display of the ribbon reserve only begins after some rotations of the ribbon roll.
To be able to display the value of the remaining ribbon length as exact as possible, some characteris-
tics of the ribbon roll have to be set:
► Set
Print > Material
>
Ribbon
>
Ribbon length
to the ribbon length in meters.
► Set
Print > Material
>
Ribbon
>
Outer ribbon Ø
to the outer-Ø (D) of the ribbon roll in millimeters.
► Set
Print > Material
>
Ribbon
>
Inner ribbon Ø
to the inner-Ø (d) of the ribbon roll in millimeters.
Inner-Ø ribbon roll = Outer-Ø ribbon core!
The default setting matches the NOVEXX Solutions standard ribbon 10287-600-xxx.
D
d
Fig. 45: Outer (D) and inner (d) diameter of the ribbon roll.
To monitor the ribbon reserve, a critical ribbon length can be set. If the remaining length falls below
this level, a warning or an error message appears - depending on the setting.
Edition 2 - 12/2021
83
Operation
Setting and Monitoring
