Novexx Solutions XLP 514, Руководство пользователя

Страница: 43 / 116

User Manual XLP 514/516
Options Options (continued) Options (continued)
Selection
Dispenser
[11]
TCS
[12]
├ Periph. device ├ Dispense Mode ├ Changelabel Mode
└ USI Signals
[13]
├ Dispenseposition ├ Changelabel Print
Basic I/O Board
[13]
├ Displaymode ├ Changelabel Length
├ Start print mode ├ Dispensecounter └ Label Eject Mode
├ Reprint signal ├ Disp. Cnt. Reset
LTMA
[14]
├ Pause input ├ Apply mode ├ Apply Mode
├ Error output ├ Start source ├ Stroke length
├ Error polarity ├ Start offset ├ Appl. Waitpos.
├ Status output ├ Start error stop ├ Applicator speed
├ Status polarity ├ Product length └ Restart delay
└ End print mode └ Rewinder Tension Keyboard
Cutter
[15]
Internal Rewinder
[16]
External signal
├ Cut mode ├ Rewinder Tension
├ Cut speed └ Rewind direction
├ Cut width
Tear-off edge
[17]
├ Cut position └ Dispenseposition
├ Double cut
└ Rest position
Rewinder
[18]
├ Rewinder Tension
├ Rewind direction
├ Rewinder Values
└ Rewinder adjust
Table 10: Parameter menu part 2 (parameters in brackets are only visible with “service mode” access rights)
11
Only with Options > Selection > Periph. device = “Dispenser”
12
Only with Options > Selection > Periph. device = “TCS”
13
Only with BasicIO board installed
14
Only with Options > Selection > Periph. device = “LTMA”
15
Only with Options > Selection > Periph. device = “Cutter”
16
Only with Options > Selection > Periph. device = “Internal Rewinder”
17
Only with Options > Selection > Periph. device = “Tear-off edge”
18
Only with Options > Selection > Periph. device = “Rewinder”
Edition 1 - 8/2021 43 Product Description
Parameter menu