06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
8
Inserting/changing ribbon
TTX / Wildcats
1. Open the lid of the printer.
2. Place the roll of ribbon on the right
ribbon mandrel (1) so that the ribbon
unwinds anti-clockwise.
3. Push the empty ribbon core onto the left
mandrel (2).
4. Introduce the end of the ribbon at an
angle from the front under the print head
bracket and between the cutter guard
and the print head bracket.
5. Then pull the ribbon upwards and lay it
over the deflection pin (3).
6. Guide the ribbon round the transport
roller anti-clockwise and fix it to the
ribbon core (you may need to wrap the
ribbon round once so that the glued part
at the start of ribbon is usable).
7. Check the ribbon for creases and make
sure it is running true. Tension the
ribbon by hand if necessary.
TDI / STDI / XXTREME
Press CUT in Offline mode, so the
display shows FOIL.
You can then push the ribbon forward
with the ON/OFF button.
Press FEED to return to Offline mode.
There is a danger of fingers, hair,
clothing, jewellery etc. being
caught up in the intake area of
the transport unit.
1
2
4
3
