06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
6
TTX1050 / S105 / Tiger XXL
1.
To gain access to the material
unwinder (1), tilt the additional
support (2) away to the side.
2.
Then insert the material as described
above.
3.
Finally, put the support back in position.
TDI / STDI / XXTREME
1.
Move the magazine down by pressing
ON/OFF + CUT.
2.
Place strips into the magazine up to the
left/rear stop.
3.
Move the magazine up by pressing
ON/OFF + FEED.
4.
Set the lateral material guides (red) on
the print module to the width of the
material. The material must be able to
slide smoothly and without play in the
guide.
Inserting Leporello
material
1. Remove the cover of the material inlet
opening using two screws (on the rear of
the device next to the interface
connections).
2. Set the outer disk of the material
unwinder to the width of the material.
3. Pull the material, with the side for
printing facing up, through the inlet
opening to the material guide.
4. Then proceed as described in the
section "Inserting material".
1
2
