Novexx Solutions ALX 92x, Руководство по обслуживанию

Страница: 716 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
27
1471 Y-Offset
Status The y-position of a layout element (graphics, text, ...) is beyond the label
margin. The element is shifted automatically to the first admissible position
at the correct side of the margin.
Measure

Check the y-positions of the layout elements and change them, if
necessary.
 Please read the notes in section Easy-Plug errors  .
1501-1535 Messages, which can occur in MLI emulation mode
Novexx Solution´s MONARCH LANGUAGE INTERPRETER™(MLI™)
helps you use a Novexx AP 5.4, 64-xx, ALX 92x, DPM or PEM printer
which was set up for use with ZIH Corp.´s ZPL II®
1)
. If you have any
questions about using a Novexx printer with these data streams, please
contact Service.
This section lists the error messages that may appear when using the
ZPL II® commands interpreted by the Novexx printer´s MONARCH
LANGUAGE INTERPRETER™.
1501 Unknown MLI Cmd
Error level 1
Status An uninterpretable command was encountered.
Measure

Check, if the printjob was proceeded correctly. If yes, ignore the message,
if no, modify the printjob.
1502 MLI Hash Error
Error level 1
Status General software error.
Measure Read chapter General software errors  on page 8.
1503 Filename Too Long
Error level 1
Status Filename is too long.
Measure  Rename the file with a shorter name.
1)
ZPL II is a registered trademark of ZIH Corp. ZIH Corp. and Novexx Solutions are not related in
any way, and ZIH Corp. has not licensed or otherwise sponsored Novexx Solution's MONARCH
LANGUAGE INTERPRETER™. MONARCH®, MONARCH LANGUAGE INTERPRETER, MLI are
trademarks of Paxar Americas, Inc.