03/10 Rev. 5.04-01
USER MANUAL
Mounting & Setting
LA-BO
15
Setting the dispensing position parameter
When using the LA-BO applicator the dispensing stop position should be set
so that the label is just released when dispensed, i.e. so that it no longer
adheres to the carrier material.
If the label is not completely dispensed but is still partially attached to the car-
rier material, the label will blown off side ways, or upside down or will not be
blown off by the LA-BO.
Advancing the carrier material too far can cause the label be pulled back under
the dispensing edge in case of strong adhesive or the following label can come
in contact with the dispensed label.
Initializing the applicator
There’s no initialization of the applicator necessary. If the ALX 92x or
ALS 20x/256 is switched on, the fan in the applicator is activated.
