Novatron Xsite EASY, Руководство пользователя

Страница: 51 / 55

To set a warning level, go to “Main menu” → “Warning levels” and choose one of the four warning
levels.
For example, to set the high limit, go to “Main menu” → “Warning levels” → “High limit”. If the high
limit is OFF, switch it ON by pressing “CHNG”. Press “Right arrow” to proceed. Lift the boom up
until the bucket or boom is near the wanted high limit and press “SET”. The upper reading on the
screen is the set warning level (values of high and low limit are compared to the main boom pin
and values of far and near limit are compared to the rotating centre point of the machine). The
lower reading in parentheses is the current position of the bucket. After setting the warning level,
go back by pressing “EXIT” (bucket button).
If any of the pivot points reach the predefined limit, the system gives the operator an alarm in the
following ways:
•
Warning sound will be played
•
Warning message will be shown in the status bar of the screen
•
Blinking exclamation mark will be shown on XD2 lightbar (XD2 is an optional accessory)
To switch OFF high/low/far/near limit, go to “Main menu” → “Warning levels” →
“High/Low/Far/Near limit”. Press “CHNG” to switch the warning level functionality OFF. Go back by
pressing “EXIT” (bucket button).
Caution
After moving the excavator, the warning levels must be reset.
Xsite EASY | User manual | Page 48 of 52
Figure 63. Pivot points and safety margins