Chapter 2 SPAN Installation
OEM7 SPAN Installation and Operation User Manual v14
70
1. Using a customer supplied wiring harness, connect a +10 to +34 VDC power supply to the power connector
(J101) on the UIC.
See
on page 275 for pinout information for the power connector.
2. Using a customer supplied wiring harness, connect power to the OEM7 receiver. See the
for information about connecting power to the receiver.
2.3.5 UIC Status LEDs
The LEDs on the UIC provide basic status information.
Figure 18: UIC Status LEDs
LED
Off
On
(Red)
On
(Green)
Flash Slow
(Yellow, 1 Hz)
Flash Fast
(Yellow, 3 Hz)
Power
No power to
UIC.
An error
occurred
during boot up
or
initialization.
UIC is powered on with
no errors detected
during boot up or
initialization.
Boot up and IMU
initialization.
N/A
Data
No
communication
between UIC
and GNSS
receiver.
N/A
UIC is transmitting and
receiving data without
errors.
UIC is receiving
data from the
receiver, but not
transmitting data.
UIC is transmitting
data to the receiver,
but not receiving
data.
Table 15: UIC Status LEDs
