11 of 33
xDR-DSP
– Diver Intercom Manual
Build 39 Date: 30-08-2021
Wireless Headsets
All systems that have the xDR-DSP installed have the possibility to integrate wireless headsets. Therefore the xDR-DSP
is sold in 3 different configurations:
The Bluetooth is controlled with the buttons on the panel, these can be seen below. If they blink green, then there is
nothing connected, if they blink blue then they are connected.
Control
The wireless headset has a few button on it, these are explained below:
Right earcup:
Volume UP
ON:
Press and Hold (2 sec.) You will hear “Power On” and the battery status “Battery High
(medium,Low)” and when already paired with the SCC you will hear “Your device is
connected”
OFF:
Press and Hold (2 sec.) You will hear “Power Off”
Volume DOWN
Left Earcup:
Volume Reduce. By Pressing you toggle between normal Volume and reduced Volume.
The last settings are stored in the memory at switch OFF
PTT button, press and Hold to speak. Only needed in All HD comms mode settings
Pairing
When connection between the headset and the system is lost, the headset needs to be paired with the system:
1. Switch the headset OFF
2. Press and hold the power button on the Headset
until you hear “Two”, then release the button.
3. Press the wireless button on the panel for 4 seconds
4. The button will start blinking blue fast
5. If the button starts blinking blue slower, then the headset is connected. the headset will also say:
“Your device is connected”
With Wireless
The system incorporates buttons and antennas on the panel and the Bluetooth print is
installed. Headsets are sold alongside the system.
Without Wireless
There is nothing installed for wireless headsets. This cannot be incorporated later.
Prepared for Wireless
The system is prepared for the addition of wireless headsets. buttons and antennas are
installed but the Bluetooth print is not yet. This can be incorporated later.
Note that when the wireless antennas and buttons are installed it does not mean that the system supports wireless
headsets. It is possible it is only prepared for it.
If this is the case then Seascape Subsea can accommodate in adding the wireless headset functions.
Blinking
Blinking
Not connected, Headset can
either be OFF or not paired
Connected
