Novanta Jadak HS-1RS, Руководство пользователя

Страница: 38 / 102

HS-1RS User Guide
Page 38
RFID Re-read Delay
This sets the time period before the HS-1RS can read the same RFID tag a second time.
Setting a proper re-read delay time protects against accidental re-reads of the same tag.
Several commonly used re-read delay menu command barcodes are included below. Use the
command
RFIDDLY x
(where ‘x’ is a value between 0 and 5000) , to set the time between 0 (no
delay) and 5000 (=5 sec.) in steps of 1ms, or by building a menu command barcode.
Please contact JADAK if assistance is needed. Default time = 1.0 seconds.
Setting examples:
No Re-read delay Re-read delay 0.5 seconds
* Re-read delay 1.0 seconds Re-read delay 2.0 seconds
RFID Reverse UID
The HS-1RS can reverse the UID data of an RFID tag when scanned. Scan the codes below to
enable or disable the reversing of the UID’s data. Default = disabled.
Reverse UID Enabled * Reverse UID Disabled
RFID Prefix
Prefix characters are user-definable data characters that can be sent before scanned data. It
is possible to enable and set a specific prefix for all scanned RFID data only.
Note: This RFID Prefix will be separate from any set Barcode prefixes or general prefixes.