22
IMS-MN-LMDE42C_A
Mounting Data
Liberty MDrive Ethernet TCP/IP
Mounting Data
Mounting Positions
NOTE:
Unless otherwise stated, all drawing measurements are in inches (mm) ±0.005”
(0.13mm).
Drawings are not to scale.
CAUTION
AXIAL AND RADIAL LOADING OF THE SHAFT
Mounting of the load to the shaft must be done with regard to the radial and axial load limits of the
motor
Failure to follow these instructions can result in injury or equipment damage.
The following mounting positions are defined and approved as per EN 60034-7:
• IM B5 drive shaft horizontal
• IM V1 drive shaft vertical, shaft end down
• IM V3 drive shaft vertical, shaft end up
IM V1
IM V3
IM B5
Mounting (Rotary Units and External Linear Actuators)
Mounting the LMDXE42X uses four (4) M3 x 0.5 screws on a bolt circle diameter (BCD) of 1.725”
(43.82 mm). The length of the screws will be determined by the thickness of the mounting
material plus a maximum of 0.140” (3.56 mm) into the motor housing.
The tightening torque of the screws is 7.8 lb-in (9 kg-cm). The following graphic shows the
rotary and actuator hole pattern.
�
1.220
(
�
30.99)
Pilot diameter
Ø 0.866 (22.00)
Ø 1.725 (43.81)
0.118 (3.00) Thru 4 Places
on a 1.725 (43.81) Circle
