9
Writing Conventions and Symbols
IMS-MN-LMDA42C_A.pdf
LMD CANopen
In addition, terms used in the present document may tangentially be used as they are derived
from other standards such as:
IEC 60034 series
Rotating electrical machines
IEC 61800 series
Adjustable speed electrical power drive systems
IEC 61158 series
Digital data communications for measurement and control – Fieldbus for use in industrial
control systems
Finally, the term zone of operation may be used in conjunction with the description of specific
hazards, and is defined as it is for a hazard zone or danger zone in the Machinery Directive
(2006/42/EC) and ISO 12100:2010.
NOTE:
The aforementioned standards may or may not apply to the specific products cited
in the present documentation. For more information concerning the individual standards
applicable to the products described herein, see the characteristics tables for those product
references.
Writing Conventions and Symbols
Work Steps
Work steps must be performed consecutively. Work steps will be numbered in order of
expected operation.
A response to a work step may be indicated. This allows verification that the work step has
been performed correctly.
Unless otherwise stated, the individual steps must be performed in the specified sequence.
Bulleted Lists
The items in bulleted lists are sorted alphanumerically or by priority. Bulleted lists are
structured as follows:
• Item 1 of bulleted list
• Item 2 of bulleted list
–
Subitem for 2
–
Subitem for 2
• Item 3 of bulleted listParameters
Parameters are shown as follows
RC
Motor Run Current
Units of Measure
Measurements are given in both imperial and metric values. Metric values are given in
parenthesis.
Examples:
1.00 in (25.4 mm)
100 oz-in (70.6 N-cm)
