Novametrix Medical Systems MARS PO2 TECH 2001, Руководство по обслуживанию

Страница: 44 / 85

Section 8
Maintenance Mains Voltage Configuration
38
Model 2001 Service Manual Rev. 01
4. Pry the fuse housing out from the power entry module.
5. Replace the blown fuse(s) with the proper type and rating.
6. Reinstall the fuse housing. When positioning the housing into the power entry module make
sure that it is oriented correctly. Press the fuse housing back into the power entry module.
7. Close the fuse access door and verify that the proper mains operating voltage is displayed.
Changing the Mains Voltage Setting
1. Check that the monitor is OFF.
2. Set the rear panel power entry module switch to OFF (“O”). Remove the line cord from the
power entry module.
CAUTION:
Replace fuses with same type and rating. Verify proper fuse value for mains voltage setting
(see table below)
.
Mains Voltage Fuses (Slo Blo)
100-120 VAC 0.5 A 250V
200-240 VAC 250mA 250V
Fuse housing
NOTE: 5 mm X 20 mm fuses are
installed toward the “back” of the
fuse housing as shown
3AG type 5 X 20mm type
OR
115V
Line operating voltage