Instruction Sheet
NovaLynx Corporation
PO Box 240 Grass Valley CA 95945
DOC 110-WS-25 IS 20210503
Phone (530) 823-7185
www.novalynx.com
110-WS-25 Quick Start
Hardware Installation
Select a level area on firm ground that will support the tripod. The area should
be away from buildings or trees that block air movement. A grassy area is
preferred as sunlight reflected from gravel or pavement could elevate the
temperature readings. If high winds are expected the legs of the tripod must
be secured to prevent tipping over.
1.
Open the tripod to the fullest extent and secure it.
2.
Assemble the wind sensor on the swaged end of the 5' mast. Secure it with
the two screws on the base of the sensor. Notice the NORTH label on the
base of the wind sensor.
3.
Assemble the mast to the tripod. Rotate the mast until the NORTH label
points north. Tighten the mounting screws on the tripod.
4.
Mount the temperature/humidity sensor on the mast.
5.
Install the rain gauge on the opposite side of the mast.
6.
The logger and barometric pressure sensor must be protected from the
weather (install indoors).
Wiring
Route the cables from the weather station to the back of the logger. If any cables must be extended
please refer to the User Manual (Appendix A) for maximum lengths allowable.
1
2
3
4
5
6
7
8
A3
GND
5 Vref
A4
A5
A6
A7
GND
W
in
d
&
R
ai
n
Te
m
p
/ R
H
/
B
P
/ A
U
X
Wind Sensor
200-WS-02F
Speed Signal
Excitation
Direction Signal
Direction GND
Speed GND
Shield
Signal
GND
Barometric Pressure
110-WS-25BP
GND
Vin
BP Signal
Temperature & Humidity
110-WS-25THA
Vin
Temp Signal
Humidity Signal
GND
Shield
Rain Gauge
110-WS-25RG
( BLACK )
( RED )
( RED )
( BLACK )
( GREEN )
( SILVER )
( BLACK )
( GREEN )
( WHITE )
( RED )
( WHITE )
( RED )
( BLACK )
( SILVER )
( BROWN )
( WHITE )
An0
An1
An2
GND
5 Vref
A1
A2
GND
1
2
3
4
5
6
7
8
DWG 890-0096-01
110-WS-25 Weather Station
