9016A
Shower Bench with Arms
Assembly Instructions
Parts out of the box:
1. Leg posts and
Back Tubes
2. Seat
Set the seat on an elevated surface
face down and place the leg marked
2 into the diagonal inset on the
bottom of the seat. (The #2 on the
seat should line up with the #2 label
on the tube. Repeat for tube labeled
#1 so that tube #2 is under tube #1.
Attach the legs by telescoping
the adjustment leg over the leg
stem and pushing the push pin
in. Be sure to adjust all four legs
to the same adjustment holes.
3. Legs
1
Hand tighten 5 screws with washers into the legs so that the
screw goes through the tube and into the seat bottom then
tighten all screws securely with a screwdriver.
4. Screws
Set the bench on the
arms by depressing
the brass push button
and inserting each
side into the arm
stems. Be sure the
pins are fully engaged
by pulling the arm.
3
2
4
Products for an
independent
life
