NorthStar 1200-02-01, Руководство по установке

Страница: 30 / 56

Section Two—Installation Instructions
PAGE 26 M3 GPS INSTALLATION MANUAL Revision D
calibration procedure aren’t accessible to the pilot, and each time the unit
is turned on, it will display the message:
To set the M3 for operation in IFR-enabled mode, perform the following
steps
:
1. Supply power to the M3 and turn the power switch on.
2. Turn the large secondary knob to
SETUP
.
3. Turn the small secondary knob all the way to the right to display:
4. Simultaneously press both
CRSR
buttons to display:
5. Press the right
CRSR
button, and use the small and large secondary
knobs to enter the code
IFR
. When done, press the right
CRSR
button
to turn the cursor off. The unit displays the confirmation message:
and will immediately switch to IFR-enabled mode.
To switch back to VFR-only mode, perform the above procedure, but enter
VFR
as the service code.
Limitations and approval procedures
The Northstar M3 GPS is designed to meet or exceed the Minimum Oper-
ational Performance Standards (MOPS) of RTCA/DO-208 and has
received Technical Standard Order approval under TSO-C129, Class A1.
TSO compliance alone is
not sufficient to substantiate airworthiness
APPROVED FOR IFR
NOTE:
The installer is responsible for ensuring that this function is
used appropriately. IFR-enabled mode is only allowed if all of
the requirements have been met and IFR approval has been
granted for the particular installation.
END OF FUNCTIONS
SVC.CODE-------
OK, THANK YOU