Northern Meditec Crius V6, Руководство оператора

Страница: 95 / 182

95 / 182
in time
：
Display mode Statements
Green light no twinkle System OK
Green light twinkle Calibrating
Blue light no twinkle Exist anesthetic gas
Red light no twinkle Sensor error
Red light twinkle Check the adapter
Note1
：
Only apply to IRMA AX+ main stream anesthetic gas module.
7.3.6 Module cleanliness
Allow to clean the probe. Before cleaning should take down the airway adapter,then use the damp
cloth that soaked in the highest concentration of 70% of medical alcohol to clean the probe,at last,
with a dry lint-free cloth to dry it.
NOTE

When do IRMA probe zero calibration should ensure it doesn’t connect with the
patient
；

Before or during do IRMA probe zero calibration
，
should pay special attention to avoid
airway adapter close to airway adapter,exist air in the IRMA airway adapter is very
important for zero calibrating successfully
；

When standard zero calibration failed, if prompt calibration failed after re-calibration,
please contct with our after-sales service department.
7.4 Sidestream CO2 module
7.4.1 Installation
1. Make sure the ventilator is turned off, connect the communication port of IRMA monitor
with the module interface cable on the backboard of the ventilator;
2. Connect Nomolinesampling tube output port to the air inlet port of ISA monitor
；
3. ISA monitor air outlet port
，
use soft tube connect to AGSS system
，
discharge the
exhaust gas together with AGSS;
4.
Connect Nomoline gas inlet port of sampling tube to the sampling port of the patient’s
breathing circuit
；