2.3 POSSIBLE PROBLEM..............................................................................
Even if the appliance is used correctly, some problems may arise for various
reasons. The table that follows mentions some possible problems and some
possible causes.
In case of problem we control first if the electrical supply to the
machine is right or not.
POSSIBLE PROBLEM
POSSIBLE CAUSES
Machine is not operating
Check if there is damage to 1) all
heating elements 2) the edge of cord
connected with the heating element
3) connector strip
Heating element is not operating
Check if there is damage to 1) the
heating element 2) the edge of cord
connected with heating element 3)
operation switch
Worm wheel is not operating
Check if there is damage to 1)on/off
switch 2) motor 3)the edge of cord
connected with the motor
2.3 REPLACEMENT OF ELECTRICAL ELEMENTS........................................
To replace the operation switch & the on/off switch of the motor unscrew the 4
screw from the right side of the appliance.
Remove the operation knob and the cover and make the replacement.
To replace the heating element unscrew the 4 screws from the right side of
the appliance remove the screw from the left of the supporting sheet of metal
disconnect the heating element from inside of the appliance and pull out the
heating element and make the replacement
To replace the motor unscrew the 4 screws from the right side of the
appliance unscrew the ball baring base and the worm wheel disconnect the
motor and replace it with a new one.
CUT OFF THE POWER SUPPLY BEFORE COVER REMOVAL.
2.4 TRAINING.....................................................................................................
The personnel who are to install and connect the appliance must train the
users appropriately so that they can handle the operation and safety
measures of the appliance.
ATTENTION !!!
•
Check that main voltage in your working area is suitable for the settings on
the label and that the appliance is properly earthed.
•
Before any service activity takes place or any parts are replaced on the
appliance, make sure that pains supply is turned off.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR
ACCIDENTS AND DAMAGE CAUSED TO PERSONS, ANIMALS OR
PROPERTY DUE TO NONCOMPLIANCE WITH THESE INSTRUCTIONS.
