Wave II Monitors
Specifications subject to changes without prior notice. The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
[email protected] www.northinvent.com
17
Function
Setting
Description
Manual input selection
"Current" box checked
"Current box" not checked
If "Input Mode" is set to "Manual" in the "Settings" tab, set active
input by checking the "Current" box.
Note that some monitor versions may have only 1 DVI and 1 DP
input, in which case the input list will be reduced to two lines.
Auto input selection
Not applicable, see "Settings"
tab.
If "Input Mode" is set to "Auto" in the "Settings" tab, the monitor
will scan for an active signal source on the inputs present in the
hardware. Full range is DVI 1, DVI 2, DP 1 and DP 2.
Priority can be set by utilizing the up and down arrows. In case of
several active inputs, the monitor will display the signal from the
highest priority with active input. If signal is lost on the active input,
the monitor will switch to the next priority input with valid signal (if
any). If valid signal reappears on a higher priority input, the
monitor will switch back to displaying this signal.
Manual DDC/CI selection
"DDC/CI" box checked
"Current box" not checked
If "DDC/CI" is set to "Manual" in the "Settings" tab, set active
DDC/CI input by checking the "DDC/CI" box.
Auto DDC/CI selection
Not applicable, see "Settings"
tab.
If "DDC/CI" is set to "Auto" in the "Settings" tab, the monitor will
listen for DDC/CI commands on all inputs simultaneously.
DDC/CI selection "OFF"
Not applicable, see "Settings"
tab.
If "DDC/CI" is set to "Off" in the "Settings" tab, the "DDC/CI"
checkboxes in the "Inputs" tab will be inactive.
