Wave II Monitors
Specifications subject to changes without prior notice. The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
[email protected] www.northinvent.com
14
8.5. Source Input Selection
The input source can be selected using the OSD (see below) or by pressing the SET button on the HMI (if available). The
Monitor will search for a video signal on all inputs or on the last selected input source if Input Mode was set to "Manual"
before powering off (see below).
To select an input, mark the corresponding radio-button in the left column. Note that some monitor versions may have only
1 DVI and 1 DP input, in which case the input list will be reduced to two lines.
