Nortel SR1001, Руководство по установке, Страница: 33 / 82

21
SR1001 Installation Guide
Version 8.3.5
Rack-Mount Installation
To mount the SR1001 in an equipment rack, follow this procedure.
Figure 14 Rack Mounting the SR1001
1 Determine the mounting position for the rack tray in the equipment rack (front or mid
mount) and attach the mounting brackets using the four (provided) 6-32 x .250 inch flat
head Phillips screws.
2 Attach the router to the carriage assembly using four (provided) Phillips pan head 4-40 x
.250 inch screws.
3 Engage the carriage assembly in the rack tray rails and slide the assembly all the way in.
4 Fit the AC strap over the power supply and then place the power supply on the rack tray
between the raised tab and the back edge of the tray.
5 Engage and tighten the AC strap captive screw to secure the power supply to the rack
tray.
6 Attach the cable retainer bracket to the appropriately-rated DC power cord behind the
molded strain relief on the cable.
7 Insert the power cable jack into the 12 VDC port on the back of the router.
8 Engage and tighten the captive screw on the cable retainer bracket in the threaded hole
adjacent to the DC input jack on the router.
9 Coil the excess cable and secure it on the tray behind the router.
10 Mount the tray in the equipment rack using either four (provided) Phillips pan head 10-24
x .5 inch screws or four (provided) Phillips pan head 12-32 x .5 inch screws, whichever fits
the equipment rack.
11 Connect the network cables to the router. Secure the cables in the clips located on the
bottom of the carriage assembly. Refer to Network Connections on page 22.
12 Connect the appropriate ends of the AC cord to the secured power supply and a 110/120
VAC outlet.
13 Using a small flat blade screwdriver, engage and tighten the captive screw to secure the
carriage assembly to the rack tray.
Mounting Bracket
Thumbscrew Engagement
Power Supply
Velcro
Mounting
Pads
Engaged Thumbscrew
Rack Carriage
Rack Tray