Nortel Passport 15000, Установка и обслуживание оборудования, Страница: 176 / 874

176 Chapter 11 Initial switch hardware installations
241-1501-240 5.2S2
Task flow navigation
The following references are listed alphabetically:
• “Cable routing” (page 86)
• “BIP power-and-ground cable installation” (page 197)
• “Connecting alarm cables to the alarm/BITS module” (page 315)
• “Connecting a CP local operator terminal cable” (page 299)
• “Connecting a temperature sensor cable assembly” (page 312)
• “Connecting an FP cable” (page 320)
• “Installing a BIM” (page 374)
• “Installing a BIP alarm module” (page 378)
• “Installing a BITS cable” (page 388)
• “Installing a blank processor card” (page 393)
• “Installing a CP” (page 399)
• “Installing a fabric card into a Passport 15000” (page 434)
• “Installing a fabric card into a Passport 20000” (page 439)
• “Installing a PIM cable” (page 487)
• “Installing a shelf assembly” (page 503)
• “Installing a shelf-based BIP” (page 512)
• “Installing a shelf-based cooling unit” (page 514)
• “Installing a strain-relief bar” (page 535)
• “Installing a temperature sensor bracket assembly” (page 536)
• “Installing an FP” (page 574)
• “Installing cable management brackets” (page 597)
• “Installing front adapter brackets” (page 610)
• “Installing grounding tape on rack uprights” (page 618)
• “Installing short adapter brackets on the front of the rack” (page 628)
• “Installing short adapter brackets on the rear of the rack” (page 624)