Nortel Millennium multi-pay M1211, Инструкция по установке, эксплуатации и обслуживанию

Страница: 271 / 350

Cleaning the terminal 8-3
Clearing debris from the coin guide slot
If debris gets stuck in the coin guide on the ID bezel:
1. Remove the debris from the coin guide by using a suit­
able instrument, such as a small knife or tweezers. If the
material is too firmly lodged to pull out, refer to Step 2.
Note: Do not probe too deeply into the validator, as this
could cause damage to the sensors.
2. If you cannot remove the debris from outside the term i­
nal, open it and remove the debris from inside. You
need maintenance-level privileges in the craft interface
to do this.
For instructions on opening the terminal, refer to
Accessing the inside of the terminal in Chapter 7.
For instructions on clearing out debris or coin jams in
the validator, refer to Coin validator jams in Chapter 6.
Chapter 6 also contains a section on clearing escrow
jams.
Cleaning the exterior of the terminal
Do not:
• use excessive amounts of water or other liquids: if they
enter the terminal, damage may occur
• use solvents as cleaners, except where noted
• use chlorinated hydrocarbon-based solvents
The polyester powder coat on some Millennium exterior
parts is a high quality, durable finish. However, these parts
are subject to abuse.
These are the cleaning and repair procedures to be used on
Millennium polyester-painted parts.
Ink stains: Alcohol-based solvents can be used, such as
isopropanol.
Millennium multi-pay terminal installation, operation, and maintenance guide