Nortel Millennium multi-pay M1211, Инструкция по установке, эксплуатации и обслуживанию

Страница: 249 / 350

Installing replaceable parts 7-73
4. Grasp the coin return assembly by placing your index
finger into the coin return door and your thumb on the
upper surface of the coin return door, as shown in Fig­
ure 7-60.
5. Lift the coin return assembly up about 3 mm, and then
pull it away from the terminal as much as possible.
6. Lift and rotate the coin return assembly above the upper
end of the coin return bezel and remove.
7. To replace the coin return assembly, reverse the pre­
ceding steps.
8. When complete, close and lock the housing assembly.
Refer to Opening the terminal, if necessary.
Replacing the rear terminal PCP
The rear terminal PCP controls the power input into the
terminal.
If the terminal has an IAS module installed, the rear terminal
PCP will be attached to the IAS module and the IAS module
will be connected to the outside line. Refer to the
interconnect diagrams in Chapter 1 to see the connections.
To replace the rear terminal PCP, follow these steps:
1. This procedure assumes you have:
• followed the directions in Preparing the terminal
for maintenance and Opening the terminal. Dis­
connect the power by disconnecting the upper ter­
minal block, shown in Figure 7-61.
• removed the coin validator - do not disconnect
the cable from the control board - as explained in
Replacing the coin validator. Set the validator
carefully down on the front housing assembly.
2. Disconnect the rear terminal PCP cable (J18) from the
control PCP connector (J5).
Millennium multi-pay terminal installation, operation, and maintenance guide