Nortel Compact ICS 7.1, Руководство координатора

Страница: 195 / 266

Telephone features / 195
N0130955 01 Compact ICS 7.1 System Coordinator Guide
Using the device attached to the internal
analog terminal adapter
The internal analog terminal adapter (I-ATA) connects a standard analog
voice device to your Compact ICS. These include such devices a single-
line telephone or a data communication device, such as a modem or fax
machine. Unlike an external adapter, the I-ATA only supports a device that
is located on the same premises as your ICS.
You activate all of the features available from the I-ATA by pressing
˚ •
on your telephone and entering a feature or access code. On
some telephones, you use FLASH instead of handsfree/mute.
If your telephone or device does not have handsfree/mute, you must use the
Hook Switch (located under the handset) to enter feature codes. Press the
Hook Switch for approximately half a second, then enter the rest of the
code.
To make an external call using the device attached to the I-ATA, you must
access an external line. To access an external line, lift the handset and enter
the external access code. The external access code is 9 or the number
programmed by your installer or customer service representative.
The feature codes for the I-ATA the telephone use
•
and
£
. If your
telephone does not have
•
, press
⁄
instead. If your telephone does not
have
£
, press
‹
instead.
To make an external call, lift the handset and enter the external access code
followed by the external telephone number. In most cases, the external
access code is 9.
Alternate line
˚¤
Allows you to switch between using your two intercom paths.
When a path is in use, you hear an error tone informing you
that the path is already in use.