Nortel CallPilot 702t, Руководство по установке и настройке

Страница: 144 / 306

Replacing a hard drive, tape drive, CD-ROM drive, or floppy drive Standard 1.0
144 CallPilot
Replacing the floppy disk drive
Introduction
The floppy disk drive is preinstalled at the factory. However, if it becomes
faulty, follow the procedure in this section to replace it.
To replace the floppy disk drive
1 Courtesy stop CallPilot, and then power down the server.
2 Disconnect the disk drive’s power and signal cables.
Note: The connectors are usually keyed to allow you to easily reconnect
them to the drive. If they are not, insert both cables so that the red wires
are closest to the center of the drive.
3 Remove and save the screw securing the drive and carrier assembly to
the 5.25-inch drive bay.
4 Slide the assembly back toward the power supply to disengage the tabs
from the slots in the bottom of the 5.25-inch drive bay.
5 Remove the assembly from the chassis, and place it component-side up
on an antistatic surface.
6 Remove the four screws that hold the bracket to the drive, and set them
and the bracket aside.
7 Place the drive in an antistatic protective wrapper.
8 Remove the disk drive from its protective wrapper, and place it
component-side up on an antistatic surface.
9 Record the drive model and serial numbers in your equipment log.
.
Risk of electrical damage
Use only floppy drives approved by Nortel Networks.