Nortel CallPilot 702t, Руководство по установке и настройке

Страница: 142 / 306

Replacing a hard drive, tape drive, CD-ROM drive, or floppy drive Standard 1.0
142 CallPilot
Replacing the CD-ROM drive
Introduction
The CD-ROM drive is preinstalled at the factory. However, if it becomes
faulty, follow the procedure in this section to replace it.
To replace the CD-ROM drive
1 Courtesy stop CallPilot, and then power down the server.
2 Set the new CD-ROM drive’s jumper settings to indicate “Master/Single.”
Note: Refer to the CD-ROM drive manufacturer’s documentation for
specific jumper settings.
3 Remove the side and front system covers, and place the front cover on a
flat surface.
4 Disconnect the faulty drive’s power and signal (IDE) cables.
5 Squeeze the plastic rail tabs toward each other as you carefully slide the
faulty drive forward out of the bay.
6 Place the device on an antistatic surface.
7 Remove and save the four screws and two slide rails.
Note: If you plan to leave the bay empty, install a filler panel and
stainless steel EMI shield on the bay.
8 Install the new CD-ROM drive in the CD-ROM drive bay.
.
Risk of electrical damage
Use only CD-ROM drives approved by Nortel Networks.