Nortel CallPilot 1001rp, Руководство по установке и настройке

Страница: 212 / 368

Performing RAID maintenance Standard 1.0
212 CallPilot
To clear the current RAID configuration
1 Power up the CallPilot server.
2 While the server is restarting, the RAID controller is detected and a
prompt appears to “Press Alt-R for RAID Configuration Options.” When
this prompt appears, press Alt-R.
Result: The Mylex Raid EzAssist program starts.
Note: If you miss the “Press Alt-R” prompt, you can press Reset to
restart the server before the system finishes booting to Windows NT. If
you reach the Windows NT Operating System selection screen, you have
missed the “Press Alt-R” prompt.
3 From the RAID controller selection window, press Enter to select the
AcceleRAID 352 controller.
Result: The main menu appears.
4 Select Advanced Options, and then press Enter.
Result: The advanced options pop-up menu appears.
5 Select Clear Configuration, and then press Enter.
Result: A warning message appears stating that this will erase all RAID
configuration information. Ignore this message for this procedure.
6 Select YES to continue.
Result: The system erases the RAID configuration.
7 Press Esc to return to the main menu.
Result: You return to the main menu.
8 Press Esc to return to the RAID controller selection window.
Result: You return to the RAID controller selection window.
9 Press Esc to exit the Mylex RAID EzAssist program.
Result: A message appears indicating that you are about to exit RAID
EzAssist and asking for confirmation.
10 Select Yes, and then press Enter.
Result: A message appears indicating that you can either power off the
system or select OK to reboot.