Nortel BCM50 2.0, Руководство по установке

Страница: 51 / 86

Chapter 7 Registering Nortel 20XX and 11XX IP telephones 51
Telephony Device Installation Guide
To access the local configuration menu on an IP telephone
1 Restart the telephone by disconnecting the power, then reconnecting the power.
After about four seconds, the top light flashes and
NORTEL NETWORKS
appears on the screen.
2 When the greeting appears, immediately, and quickly, press the four display buttons on the
2000 series (three on the 2033 model), one at a time, from left to right. These buttons are
located directly under the display (see
Figure 12 on page 53 ).
Press the button sequence within 1.5 seconds; otherwise the telephone does not enter
configuration mode.
• If
Manual Cfg DHCP(0 no, 1 yes)
appears on the screen, you successfully accessed the
configuration mode.
• If any other message appears, disconnect, then reconnect the power, and try to access the
configuration mode again.
3 Enter the network parameters, as prompted.
4 As each parameter prompt appears, use the keypad to define values.
5 Use the * key to enter the period in the IP addresses.
6 Press OK to move forward.
To access the local configuration menu on an IP Phone 2001/
2002/2004
1 Restart the telephone by disconnecting the power, then reconnecting the power.
After about four seconds, the top light flashes and
NORTEL NETWORKS appears on the screen.
2 When the greeting appears, immediately and quickly press the four display buttons one at a
time, from left to right (see Figure 12 on page 53 ). These buttons are located directly under the
display.
To access the local configuration menu on an IP Phone 2033
1
Restart the telephone by disconnecting the power, then reconnecting the power.
After about four seconds, the top light flashes and
NORTEL NETWORKS
appears on the screen.
2 When the greeting appears, immediately and quickly press the three display buttons one at a
time, from left to right (see
Figure 12 on page 53 ). These buttons are located directly under the
display.
To access the local configuration menu on an IP Phone 2007
1 Restart the telephone by disconnecting the power, then reconnecting the power.
After about four seconds,
NORTEL
appears on the screen.
2 When the greeting appears, immediately and quickly press 007* on the dialpad.