Nortel Agent Greeting 2.0, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 18 / 38

Page 18 of 36 Agent Greeting Card Test and Debug Capabilities
297-2183-502 Release 2.0.1 June 2001
-> upgradePCMCIA “/A:agent_greet.bin”<CR>
Updating sector: 16..17..18..19..20..21..22..23..file read complete
Program Address = 0xf9900000, Checksum = 0x51a4737d,length = 0x76338
Upgrade completed OK
Reboot the pack to run new loadware
value = 0 = 0x0
Loadware upgrade from a FTP Server
To upgrade the loadware over the network from an FTP server you must copy
the loadware binary file to an FTP server The upgrade is then performed by
running the “upgrade” command in the VxWorks shell as shown below:
-> upgrade “<server IP address>”,“<userid>”,“<password>”,
“<path>”,“agent_greet.bin”<CR>
Connecting to <server IP address>...
connected to <server IP address OK>
Updating sector: 16..17..18..19..20..21..22..23..file read complete
Program Address = 0xf9900000, Checksum = 0x51a4737d,length = 0x76338
Upgrade completed OK
Reboot the pack to run new loadware
value = 0 = 0x0
The <userid> and <password> above are those of the FTP server and the
<path> above is the path to the file on the FTP server.
Note: The updated sectors for Bank 1 start at sector 16 (as in example
above) whereas the start sector for Bank 0 is sector 0. Successive
successful upgrades alternate between banks for storing the upgrade
image.
The Agent Greeting Card must be in maintenance mode before an upgrade
can be executed. Maintenance mode is entered by disabling the card via
Overlay 32 on the Meridian switch. Once upgrade is complete the card can be
reenabled via Overlay 32.