Nortel 703t, Техническое обслуживание и диагностика

Страница: 54 / 248

Using Windows online diagnostic tools Standard 1.06
54 CallPilot
The ping command
The ping command sends an echo request to a specified host. Use this
command to verify network connectivity to the remote device.
Ping command syntax
The ping command uses the following syntax:
ping [-t] [-a] [-n count] [-l size] [-f] [-i TTL]
[-v TOS] [-r count] [-s count]
[[-j host-list] | [-k host-list]]
[-w timeout] destination-list
Table 5: Ping command parameters
Parameter Description
-t Pings the specified host until interrupted.
-a Resolves addresses to host names.
-n count Specifies the number of echo requests to send.
-l size Sends buffer size.
-f Sets Don’t Fragment flag in packet.
-i TTL Sets Time-To-Live
-v TOS Sets Type Of Service
-r count Records route for count hops
-s count Shows time stamp for count hops
-j host-list Shows loose source route along host list
-k host-list Shows strict source route along host list
-w timeout Sets time-out in milliseconds to wait for each reply