Nortel 703t, Техническое обслуживание и диагностика

Страница: 44 / 248

Troubleshooting your CallPilot system Standard 1.06
44 CallPilot
3 If the problem continues, the drive is faulty. Replace the hard drive
as described in “Replacing a faulty hard drive” on page 147.
When the 703t server boots to the operating system and makes
audible beeps
If the 703t server boots to the operating system but still makes audible
beeps, one of the hard drives is in critical condition.
To check if server has a hard drive in critical
condition
1 Rebuild the hard drive as soon as the operating system has finished
loading. Refer to “RAID splitting” on page 181.
When the 703t server boots to the operating system but does
not boot to CallPilot
If the 703t server does not boot to CallPilot, it may be due to the failure
of a multimedia board.
To check if multimedia board has failed
1 Check the diagnostic screen that is displayed immediately after you
reboot the system, and view the event logs. For instructions, see
“Viewing event logs” on page 48.
2 If the diagnostic or event log information indicates failure of a
multimedia board, replace the card as described in “Replacing
MPB96 boards” on page 191.
3 If the diagnostic or event log information does not indicate failure of
a multimedia board, a software failure is the likely cause.
Refer to the Software Administration and Maintenance Guide
(555-7101-202) for instructions on how to reinstall software.