Nortel 703t, Техническое обслуживание и диагностика

Страница: 151 / 248

January 2007 Replacing media drives
703t Server Maintenance and Diagnostics 151
To remove a hard drive from the server
1 Prepare the server for hard drive replacement as follows:
a. Shut down the server, and then disconnect the power and
peripheral device cables.
b. Remove the side cover.
c. Remove the upper fan holder foam.
For instructions, see “Preparing the server for hardware
maintenance” on page 120.
2 Open the front panel on the server.
3 Remove and save the two screws that secure the drive’s carrier to
the front of the chassis.
4 Pull the drive out slightly—about 1 cm (0.5 in.).
Pulling the drive out creates more space between the front system
fans and the drives inside the server so that you can disconnect the
cables.
5 If required (to provide more space), temporarily remove the front
system fans from their slots in the bottom fan holder foam. (Do not
disconnect the fans’ power cables.)
.
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
.
WARNING
Risk of personal injury or equipment damage
Failure to follow the procedures in “Preparing the
server for hardware maintenance” on page 120 can
result in electrical shock or equipment damage.