Nortel 703t, Техническое обслуживание и диагностика

Страница: 102 / 248

Using CallPilot Manager to monitor hardware Standard 1.06
102 CallPilot
Note: For an explanation of the channel states, refer to the CallPilot
Manager online Help .
3 Do one of the following:
4 Click Courtesy Stop, Stop, or Start as required.
Result: If you clicked Courtesy Stop or Stop, you are asked to
confirm the Courtesy Stop or Stop. Click OK.
The selected channels change to idle or on-duty status, according
to the action you chose.
If the buttons are not available, wait a few seconds for the screen to
refresh:
„
The Courtesy Stop and Stop buttons are available only when a
component is in one of the following states: Idle, Active, Remote
Alarm, Local Alarm.
IF you want to stop or start THEN
all of the channels
associated with a DSP check the check box to the left of
the DSP that you want to stop or
start.
Repeat this step for each DSP.
only one or several
channels that are
associated with a DSP check the check box for each
channel that you want to stop or
start.